C1905 Code failures by brands


Description of DTC code C1905

Vehicle handling is determined by factors such as road conditions, weight, speed, among others. All of them tend to vary constantly, that is why the ride control is implemented. A key role in this system is played by the car's suspension, which must have its components in good condition to ensure proper driving.

However, many of the suspension components have changed over time. This fact does not affect the system's objectives. These objectives are to provide steering balance and improve conditions for greater comfort for the vehicle's occupants.

When the C1905 OBDII diagnostic code C1905 is set, it is because a fault is found in the ride control. For Mercury, Ford, and Lincoln manufacturers. This code means that the left rear shock actuator has malfunctioned.

Symptoms of fault code C1905

  • Check Engine light ON.
  • Anti-lock Braking System (ABS) warning light ON.

Causes of OBD2 C1905

Reasons for setting the C1905 OBD2 fault code:

  • There may be bad wires or connectors in the left rear shock actuator circuit.
  • The electrical connections of the actuator circuit may be faulty.
  • The left rear shock actuator of the ride control may be defective.
  • The Suspension Module may be defective.

Possible solutions of the DTC code C1905

Steps to solve DTC C1905 OBDII code:

  • Consult the Technical Service Bulletins (TSB).
  • Verify the good condition of the electrical components of the shock actuator circuit. If they show burn spots, wear, or corrosion, make the necessary repairs or replacements.
  • Perform voltage checks on the actuator circuit. Then, compare these readings with those given in the service manual. If you discover big differences, make corrections as applicable.
  • Check the left rear shock actuator for damage. Follow the manufacturer's recommendations. If it is faulty, replace it.

Codes related to C1905

Leave a Reply

Your email address will not be published.